Difference between revisions of "Translations:AY Honors/Knot/Man harness/2/en"

Latest revision as of 19:26, 25 July 2022

Information about message (contribute)

This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.

Message definition (AY Honors/Knot/Man harness)

</noinclude>
{{Knot
| name = Man harness knot
| image = ArtilleryLoop FinalKnot.jpg
| image2 = ArtilleryLoop_HowTo.jpg
| use = The '''Man harness''' is a knot with a loop on the bight for non-critical purposes. This knot is used when multiple people are to pull a load. Typically one end of the rope is tied to a load, and one man harness knot per puller will be tied along its length. Each loop is then pulled by a different person.
| warnings = The Man harness knot must have the loop loaded or it will slip and contract easily.
| tying_instructions =
# Lay the rope flat
# Make a loop in the rope with the running end going beneath the standing part.
# Pull the running end down so that it crosses over the loop.
# Pull the bottom of the loop through the gap between the top of the loop and the running end.
}}
<noinclude>

</noinclude>
{{Knot
| name = Man harness knot
| image = ArtilleryLoop FinalKnot.jpg
| image2 = ArtilleryLoop_HowTo.jpg
| use = The '''Man harness''' is a knot with a loop on the bight for non-critical purposes. This knot is used when multiple people are to pull a load. Typically one end of the rope is tied to a load, and one man harness knot per puller will be tied along its length. Each loop is then pulled by a different person.
| warnings = The Man harness knot must have the loop loaded or it will slip and contract easily.
| tying_instructions =
# Lay the rope flat
# Make a loop in the rope with the running end going beneath the standing part.
# Pull the running end down so that it crosses over the loop.
# Pull the bottom of the loop through the gap between the top of the loop and the running end.
}}
<noinclude>

Man harness knot

Use: The Man harness is a knot with a loop on the bight for non-critical purposes. This knot is used when multiple people are to pull a load. Typically one end of the rope is tied to a load, and one man harness knot per puller will be tied along its length. Each loop is then pulled by a different person.

How to tie:

Lay the rope flat
Make a loop in the rope with the running end going beneath the standing part.
Pull the running end down so that it crosses over the loop.
Pull the bottom of the loop through the gap between the top of the loop and the running end.

WARNING: The Man harness knot must have the loop loaded or it will slip and contract easily.