Respuestas para la especialidad JA de Globoflexia
Nivel de destreza
2
Año
2018
Version
08.01.2026
Autoridad de aprobación
Unión Australiana
1
2
The risk of bursting can be reduced by making sure there is not too much pressure in the balloon when twisting. Always make sure there is sufficient uninflated balloon left to allow for your twisting, and always release some air pressure immediately after inflating (sometimes referred to as ‘burping’) to soften the balloon and make it easier to twist and tie off.
When twisting ‘bubbles’ in a modelling balloon it is always important to twist the balloon in the same direction for every bubble. Otherwise your bubbles will untwist as you move along the balloon and you will have to start again.
The following information on basic twists has been sourced from Professor Wonder.
2a
Twist two bubbles, usually about the same size. Bring the opposite ends together so that the two bubbles are parallel and touching each other. Twist them together to lock in place. (This is the most common method of making legs and ears on simple figures).
2b
Similar to the lock twist but done with one long bubble instead of two shorter ones. Take a long bubble, fold it back on itself, and twist the two ends together. (This is good for large ears, hands or feet on multiple balloon figures).
2c
Twist a small bubble, leaving it a little soft. Twist the two ends of the same bubble together. (This is good for ears, lips, or often used to hold another bubble in place).
2d
Push the knot about 5cm down into the balloon with your index finger. With the other hand, pinch the outside of the balloon and grab the knot. Carefully pull out your finger and twist a bubble at the point where you pinched the balloon on the knot.
3
If you have one of the introductory books on balloon modelling this will be where you start learning how to create balloon sculptures. Once you are ready to expand your expertise the internet is your friend! There are a plethora of balloon artists and resources available online to instruct and inspire, from the most basic of techniques and balloon sculptures to advanced designs incorporating multiple balloons. Below are some examples to get you started in creating balloon models of your own:
Some YouTube Channels
Some Pinterest Boards
4
There are many ways balloon modelling can be used in outreach ministry. Sometimes it will be as simple as giving balloon sculptures as gifts or mementos, but additionally balloon modelling can be used in storytelling and object lessons.
Using balloon modelling in storytelling or object lessons could be as simple as making/using a balloon sculpture as a prop for the audience to watch as you tell a story, but make sure it is not too distracting such that your audience misses the story itself! If you are making the sculpture as you talk it is also worthwhile practicing your timing so make sure there aren’t long periods of silence as you work on your model if possible.
Some more in-depth examples of object lessons using balloon modelling are below. But most importantly don’t limit your own creativity!
Jonah (Pastor Andrew):
